http://i1092.photobucket.com/albums/i413/mtgsd/support/ossbannerdeskcom57.png?width=699&height=129&xn_auth=no&type=x-png
Welcome, Guest Login

Support Center

How to Power up PE6R4-I non-enclosed board?

Last Updated: Sep 09, 2016 03:37PM PDT

Product: PE6R4-I board set

 

Question:

How to Power up PE6R4-I non-enclosed board??

 

Answer:

If you just have the PE6R4-I NE boardset without the power on/off switch cable assembly you need to connect or place a jumper on J200  You need to to put the jumper on  pins SW & GND (OR pins 1&2) pin 1 is on the right hand side.

 And you connect the primary ATX power to J12

 

 

 

 

 

Contact Us

  • Email Us
  • Support Resources
      Videos
      Documents
      Software
      Troubleshooting
desk@onestopsystems.com
https://cdn.desk.com/
false
desk
Loading
seconds ago
a minute ago
minutes ago
an hour ago
hours ago
a day ago
days ago
about
false
Invalid characters found
/customer/en/portal/articles/autocomplete